Rugged Ridge Trailer Wiring Harness, 07-14 Jeep Wrangler (JK) User Manual
Page 1
17275.01 - JK Tow Hitch Wiring Kit
Installation instructions - JK Tow Hitch Wiring Kit
Contents:
(1) JK tow hitch wiring loom with
connecters and plug.
Page 1
PAGE 1
Note: Read instructions fully before proceeding with installation. Loom has been designed to plug directly
into factory connectors. Can be used with either factory 2" tow hitch or Rugged Ridge 2" tow hitch
P/N: 11580.01 (sold separately).
Step1: Place vehicle in gear and set the
emergency brake. Remove rear
driver's side taillight (pic.1).
Step2: Disconnect taillight connector as
shown. (pic.2)
Step3: Connect new loom to mail and female
connectors (pic.3)
Step4: Fish trailer connecter down through
taillight opening and past foam
isolator panel. (pic.4 & 5)
Step5: After pulling loom through foam
isolator drop connector over frame
and insert into tow hitch plug notch
(pic.6).
pic.3
pic.4
Step6: Locate small 8mm holes drilled
along frame and press in retainer
clips (pic.7)
Test all light functions before towing.
pic.1
pic.2
pic.5
pic.6
pic.7