Rugged Ridge Spare Tire Spacer, 76-14 Jeep CJ & Wrangler User Manual
Spare tire spacer
Copyright © 2013 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Spare Tire Spacer
1.
Body
Mount
(1)
2.
Wheel
Mount
(1)
3.
Flat
Washer
(5)
4.
Lock
Washer
(6)
5. Locking Hex Nut
(2)
6. M12 x 1.25 x 35 Hex Bolt
(3)
7. M12 x 1 x 30 Hex Bolt
(2)
8. M12 Hex Nuts
(3)
9. 1/2-20 Hex Nuts
(3)
10. M12 x 1.25 Lug Nuts
(3)
1. Remove spare tire. Install Body Mount using Flat
Washers and Lock Washers. Depending on factory
stud sizes use either M12 Hex Nuts, or 1/2” Hex Nuts
to attach Body Mount to vehicle.
NOTE: M12 Nuts will install on on 1/2 factory stud, but
will NOT be secure. 1/2” Nuts will NOT install on M12
factory stud.
Page 1/2
11585.02
Components:
OMIX-ADA
®
TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Read all instructions thoroughly before installation.
Rev 09/2013
10
9
8
3
1
5
6
4
2
7