Rugged Ridge Stinger for XHD Modular Front Bumper - Manual

11540.13
Jeep
®
JK Wrangler Modular HD Front Bumper Stinger
Contents:
1. Stinger (1)
1. If installing as part of a new installation, place center section of bumper onto frame rails, but do not
yet attach. If stinger is being added to an existing installation, remove existing Hoop and D-Rings
from center section. Center section should be sitting on the frame rails, but not attached (Figure 1a).
Place Stinger over center section (Figure 1b) and align 8 holes on top and 8 holes on front (Figure 1c).
Figure 1a Figure 1b Figure 1c
2. Install 8 top bolts (provided with center section) through the stinger and into the center section
(Figure 2a). Do not tighten bolts yet. Install 8 front bolts (provided with center section) through the
stinger and into the center section (Figure 2b).
Page 1 of 2
Figure 2a Figure 2b
1