Rugged Ridge Rock Crawler Rear Bumper, 97-06 Jeep Wrangler User Manual
Install new omix rear rock bumper on vehicle, Fig. a) frame cross-member mounting location
Part Number: 11546.01
TJ Rear Rock Bumper
Installation Instructions
1.
Remove the rear stock bumper and keep lower mounting hole bolts.
2.
Install new Omix rear rock bumper on vehicle.
Note: Use supplied 3/8” bolts with lock washers in all 8 upper cross
member mounting locations. Torque bolts between 30-35 ft lbs.
reuse lower stock mounting bolt an torque between 40-45 ft lbs.
Some TJ models may not have full 8 upper mounting holes in
the vehicles rear frame cross-member. If vehicle does not have
all 8 mounting holes than used the measurements below to drill
the additional 4 holes at points indicated. Drill the frame cross-
member holes to 7/16”. See Figure A
(Fig. A) Frame Cross-member mounting location.