Rugged Ridge Aluminum Rear Bumper Pods, 07-14 Jeep Wrangler - Manual

Part number: 11547.01
Jeep
®
JK Wrangler Rear Bumper Pods (2dr - 4dr Unlimited)
Contents:
1. Rear LH Bumper Pod (1)
2. Rear RH Bumper Pod (1)
3. Left Bracket (1)
4. Right Bracket (1)
5. D-Ring (2)
6. 12mm Washer (8)
7. 12mm Bolt (11)
8. Plugs (6)
9. 12mm x 90 long Hex Head Bolt (2)
10. 12mm x 38mm OD Flat Washer (6)
11. Right Rear Stabilizer Bracket (1)
12. Inner Frame Nut Plate (2)
13. 12mm Short Hex Head Bolt (2)
14. 12mm Lock Nut
1. Remove original rear bumper. It is held in by 2 bolts on each side (Figure 1a), and 2 bolts that are
attached to brackets which fasten to the rear crossmember (Figure 1b). After the bumper is
removed, remove the small brackets from the rear crossmember (Figure 1c). Save the 4 bolts
from the side and the 2 bolts from the crossmember, as they are to be re-used.
Figure 1a Figure 1b Figure 1c
2. Place Bracket on rear frame rails. Brackets need to be angled up while sliding over frame rail
(Figure 2a), and then dropped down to level once crossmember hook has been cleared (Figure 2b).
Use 2 rear bolts removed in Step 1 to bolt brackets to frame (Figure 2c) and one for the rear
crossmember. Secure the front using new M12 nut plate , M12 bolt and flat washer. Do not tighten.
Page 1 of 2
Figure 2a Figure 2b Figure 2c
Rev. 1 (7/15/2011)