Rugged Ridge Rock Crawler Front Bumper, 97-06 Jeep Wrangler User Manual
Rugged Ridge For the car
Advertising
1.
Remove the front stock bumper and keep all mounting hole bolts.
2.
Install new Rugged Ridge front rock bumper on vehicle.
Note: Please keep all mounting bolts as they will be reused. A size 55
torx bit will be needed to remove original mounting bolts from vehicle.
After the new bumper has been installed on the front of vehicle, hand tighten
all bolts into place. Using the torx bit, tighten all bolts to secure bumper to frame.
If installing new tow hooks used supplied hardware for upper mounting holes.
Advertising
Table of contents