Rugged Ridge 3-Inch Double Rear Tube Bumper, 07-14 Jeep Wrangler - Manual

11573.10 Tube Bumper - Stainless Steel
11571.10 Tube Bumer - Textured Black
11503.15 RRC Bumper - Texture Black
Jeep
®
JK Wrangler Rear Tube Bumper / Rear RRC Bumper
1. Remove original rear bumper. It is held in by 2 bolts on each side (Figure 1a), and 2 bolts that are
attached to brackets which fasten to the rear crossmember (Figure 1b). After the bumper is
removed, remove the small brackets from the rear crossmember (Figure 1c).
Figure 1a Figure 1b Figure 1c
2. Place Filler Panel on rear frame rails (Figure 2). No fasteners are to be installed yet.
Page 1 of 2
Figure 2
*Note - Tube Bumper shown. RRC Bumper installs the same
Contents:
1. Bumper* (1)
2. Filler Panel (1)
3. Left Plate (1)
4. Right Plate (1)
5. 12mm Washer (4)
6. Lock Washer (4)
7. 12mm Bolt (4)
8. 6mm Washer (4)
9. 6mm Hex Head Screw (2)
10. 6mm Lock Nut (2)
1
6
7
9 2 3
10
8
4
6
7
5
5
8
9