Rugged Ridge Alumunium XHD Rear Bumper Step, 07-14 Jeep Wrangler - Manual

Part number: 11547.10
Jeep
®
JK Wrangler Aluminum Center Bumper Step (2dr - 4dr Unlimited)
Contents:
1. Center Pod Step (1)
2. Center Mounting Bracket (2)
3. M8 Nut Plate (2)
4. M8 Counter Sunk Bolt (4)
5. Allen Head Tool (1)
6. M12 Long Hex Bolt (4) - not shown
7. M12 Flat Washer (8) - not shown
8. M12 Nylock Nut (4) - not shown
1. Factory rear bumper will need to be removed. See rear bumper pod instructions (11547.01) for
correct procedure. If vehicle is equipped with a factory receiver loosen and remove the 4 bolts
securing hitch in place (Fig.1a). Slide center mounting brackets onto frame cross member and
and over receiver (if equipped). Align mounting holes (Fig.1b) and install supplied 4” M12 bolts,
washers and Nylock nuts. Secure brackets to bumper, DO NOT TIGHTEN at this time (Fig.1c).
Figure 1a Figure 1b Figure 1c
2. Center mounting brackets on cross member (Fig.2a). Open rear tailgate and place center step
onto mounting brackets (Fig.2b). Make sure step is centered between bumper pods (Fig.2c).
Page 1 of 2
Figure 2a Figure 2b Figure 2c
Rev. 1 (9/27/2011)