Rugged Ridge Winch Mounting Spacers, 07-14 Jeep Wrangler (JK) - Manual

11540.15
Jeep® JK Wrangler Modular HD Front Bumper -
Spacers for use with Warn® Powerplant Winch
Contents:
1. Spacer Blocks (2)
2. 3/8-16 x 2.25" Bolts (4)
3. 3/8 Flat Washer (4)
4. 3/8 Lock Washer (4)
1. Winch can be installed with the Bumper on or off of the vehicle. Remove any Hoops from the Bumper.
Install Fairlead to Bumper. Note - bolts for Fairlead (supplied with it) should pass from inside the Winch
cavity, with the nut being installed on the outside (Figure 1a). Tighten Fairlead bolts (Figure 1b).
2. Prepare Winch and vehicle for installation as specified in winch installation instructions. Align holes
in bumper as shown below (Figure 2a) with Spacers and winch mounting holes (Figure 2b). It may
be helpful to thread winch cable through fairlead before bolting it in place. Install winch as instructed
by winch manufacturer, but substitute standard bolts supplied with the winch for longer bolts supplied
with the spacers.
Page 1 of 2
Figure 1b Figure 1a
Note: Spacer Blocks are required when using the Warn® Powerplant Winch. Most winches can bolt directly to the
Bumper without using these.
Use these holes to mount
Powerplant® Winch.
Use these holes to mount
Powerplant® Winch.
Figure 2a Figure 2b
1
3
4
2