Rugged Ridge Double X Striker, Black, 76-86 CJ, 87-14 Jeep Wrangler (JK) - Manual

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 1/1
11540.25
Rugged Ridge XHD Double X Striker
OMIX-ADA ® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Contents:
• Double X Striker
(1)
4. Install front 8 bolts and washers (provided with center
section). Do not tighten bolts.
5. Once all 16 bolts have been started, tighten the front 8
bolts, followed by the top 8 bolts. Installation is now com-
plete.
To avoid serious injury: never exceed 6.5 ton
working load on D-Ring mounts. Use only to
assist in vehicle self-recovery; never use D-Ring
mounts as towing point. Inspect before use.
Replace if damaged or distorted. Striker Bar is
not to be used for towing or vehicle recovery.
1. If Double X Striker is being added to an existing instal-
lation; remove D-Rings and/or any top or front mounted
accesoires from center section. Center section should be
sitting on frame rails but not attached.
2. Place Double X Striker over center section and secure
with 8 top bolts and washers (provided with center sec-
tion). Do not tighten bolts.
WARNING !