Rugged Ridge Cold Air Intake Kit, 4.0L, 97-06 Jeep Wrangler (TJ) - Manual

Page 1 of 4
17750.01
TJ Cold Air Intake - 4.0
Contents:
1. Intake Tube (1)
2. Heat Shield (1)
3. Weather Stripping
4. Air Filter (1)
5. Throttle Body Coupling (1)
6. Large Hose Clamps (3)
7. Breather Hose (1)
8. Small Hose Clamps (2)
9. Throttle Body Spacer (1)
10. Throttle Body Gaskets (2)
11. M6 Throttle Body Bolts (4)
12. Throttle Linkage Spacers (3)
13. M6 Throttle Linkage Bolts (3)
14. M8 Mounting Bolt (1)
15. M8 Flat Washers (2)
16. M8 Nut (1)
17. Rubber Isolator Mount (1)
18. M6 Washers (2)
19. M6 Nuts (2)
20. Zip Tie (1)
21. Grommet
1. Remove original Air Filter, Air Box, Intake Tube, Intake Temperature Sensor, and Breather Tube.
2. Install Rubber Isolator Mount to the vehicle in the rear-most hole that was utilized by the stock air box.
Fasten to vehicle using M6 Flat Washer and M6 Nut from below.
Rubber Isolator