Rugged Ridge Dual Battery Tray, 70-90 Jeep CJ & Wrangler - Manual

Contents:
(1) Dual Battery Tray
(1) Firewall Support Bracket
(1) Inner Fender Brace (YJ)
(1) Diagnostic Plug Bracket
(YJ optional)
(1) Fender shield
(2) Phillips Head Screws
Page 1 of 2
11214.50 Dual Battery Tray
Applications: 1970 - 86 CJ5, CJ7, and CJ8
1987 -90 YJ Wrangler
Dual Battery Tray Installation Instructions CJ/YJ 1970-1990 (No Drill Application)
Step 1: For CJ applications remove Jack
and tire tool. These items will need
to be relocated. If desired the handle
can be shortened by 4" and secured
back in the original location.
Step 2: Disconnect Battery by removing the
NEG (-) cable first and then the POS
(+) connector. Remove battery from
tray.
Step 3: For YJ applications remove relays
by releasing holding tabs. This can be
done using pliers. If the vehicle is
equipped with diagnostic plugs
disconnect at this time.
Step 4: Unbolt old tray and remove. Retain
all mounting bolts and any clips.
They will be reused.
For CJ applications remove lower
tray braces.
Step 5: For YJ applications (if equipped)
remove and relocate emission
vent sensor and vacuum 4WD
indicator assembly. Relocate to
stud located above and to the
right on firewall.
Step 6: For YJ applications install fender
brace to three studs on bottom of
Dual Battery Tray. Use 10mm hex
nuts (do not tighten).
Step 7: Install Fire Wall Support Bracket to
Dual Battery Tray with 14mm Hex
Nut (do not tighten). Install lower
fender shield using two 10mm Hex
Head Nuts. Plate attaches to the
bottom of Dual Battery Trays front
right corner. Secure nuts.
Step 8: Install Dual Battery Tray to vehicle.
Reuse mounting bolts removed in
step 4. Adjust tray as needed and
tighten all bolts and hex nuts at this
time.
Step 9: For YJ application install supplied
Diagnostic Plug Bracket if needed.
Harness should be pulled to the
right side of tray. Feed plug through
opening in bracket and attach with
supplied screws.
If equipped, snap relays into Diagnostic
Plug Bracket.
Step (2) Step (4)
Step (6) Step (8)
(3) Threaded "J" Hooks
(3) Nylon Flat Washers
(3) Wing Nuts
(1) Battery Retainer Bar
(7) Bracket 10mm Hex Nuts
(1) 14mm Support Bracket Hex Nut