Rugged Ridge Hood Lift Kit, 07-14 Jeep Wrangler (JK) User Manual
Jk hood prop
Advertising
Page 1 of 2
Contents: Quantity:
Lower Mounting Bracket
Upper Mounting Bracket
Nut Plate
Threaded Ball Stud
Nyloc Nut
M6 x 18 Bolt
M6 Nyloc Nut
M6 Washer
M5 x 16 Bolt
M5 Washer
Struts
Rubber Gaskets
JK Hood Prop
(2)
(2)
(2)
(2)
(2)
(2)
(2)
(4)
(4)
(4)
(2)
(2)
11252.51
9/23/10
2.
Insert supplied M6 bolt and M6 washer through preexisting hole in the sheet metal behind the fender
bolt (Figure 3). Rotate bracket up and push bolt through the lower mounting bracket. Place another M6 washer
over bolt and thread on the M6 nut. Fully tighten both the fender bolt and the M6 bolt, washer, and nut
assembly.
1.
Place the hood in the open position using factory hood prop. Remove the 10mm fender bolt closest to
Figure 1. Figure 2.
Figure 3.
Advertising