Rugged Ridge Throttle Body Spacer, Rugged Ridge, Jeep Wrangler (JK) 07-11 3.8L User Manual
Caution, Jk throttle body spacer
Advertising
Page 1 of 2
Contents: Quantity:
Throttle Body Spacer
(1)
Throttle Body Spacer Gasket
(1)
M6 x 70 bolts
(4)
JK THROTTLE BODY SPACER
CAUTION!
Engine systems must be cool before installation can begin.
3.
Disconnect the electrical connector from the bottom of the throttle
body.
2.
Loosen the 4, 8mm, bolts holding the throttle body to the intake
manifold. Remove throttle body.
1.
Disconnect the battery. Disconnect the Air Intake Temperature (AIT)
sensor from the stock air inlet tube. Loosen the hose clamps from both sides
of the air inlet tube and then remove the tube.
17755.02 JK Throttle Body Spacer
Washers (4)
Advertising