Rugged Ridge XHD High Mount Snorkel Extension, 07-14 Jeep Wrangler (JK) - Manual (Page 2)

Page 2 of 3 REV.1 06/25/2012
High Intake Installation Instructions: (2007 - UP) Wrangler 2DR & 4DR Unlimited
P/N: 17756.07 - XHD Modular High Mount (Ram intake)
High mount installation:
5
- Install mounting bracket
the back of high mount
intake using (2) M6 hex
head bolts and washers.
secure bolts but do not
tighten at this time.
6
- mount bracket and intake
to windshield bracket
using T-40 torx bolts
removed in step (4).
Secure bolts but do not
tighten.
4
- Use a T-40 torx head socket
to remove top (2) windshield
bracket bolts. Do Not discard.
Bolts will be reused.
7
- Insert (4) M6 caps head
bolts and washers through
intake to snorkel main
body. Tighten bolts.
DO NOT OVER TIGHTEN.
Tighten enough to insure
tight fit of gasket to snorkel
main body.
8
- Tighten mounting bracket
to windshield.
9
- Tighten mounting bracket
to high intake M6 bolts.
Turn on windshield wipers
to check for clearance.
Adjust as needed.
NOTE: vehicle must be
equiped with OE correct
16” wiper blades.