Rugged Ridge Reusable Air Filter, 72-91 Jeep CJ & Wrangler - Manual

RUGGED RIDGE SYNTHETIC AIR FILTER CLEANING INSTRUCTIONS
Step 1. Remove your re-usable air filter from your factory air box or Rugged Ridge air
intake system. The factory air box and or area around the filter will need to
be cleaned also.
Step 2. Lightly shake or tap the filter to remove large debris and excess dirt. A soft
bristle paint brush may be needed to dislodge debris from the pleats in the
filter.
Step 3. Clean filter with dish soap or a mild degreaser spray and water. Allow cleaner
to soak in to penetrate dirt and debris. Do not allow cleaner to dry on filter.
No more than 5 to 10 minutes.
Step 4. Thoroughly rinse filter with clean water. Do not use high pressure water to
rinse. Allow air filter to air dry completely. For best results place air filter in
open sunlight. Once the filter is completely dry re-install in your vehicle.
NOTICE ! Do not use compressed air or high pressure water to clean filter. Do not expose filter to open
heat or flame to dry. Excessive force will damage the filter. Oil is not needed for filter.
REV 09/22
For Technical Assistance Contact: Phone: 1-800-449-6649
OMIX-ADA Tech Support Email: [email protected]
Web: www.Omix-Ada.com