Rugged Ridge Throttle Body Spacer, 3.6L, 12-14 Jeep Wrangler (JK) - Manual

2012 -Up 3.6L Throttle Body Spacer (JK ) 2dr , 4dr
Page 1
P/N: 17755.03 Rev (1) 7/02/2012
Item List:
(1) Aluminum Spacer
(1) Gasket
(2) M6 x 60 Shank bolts (Long)
(2) M6 X 55 Shank bolts (Short)
(4) M6 Flat Washer
Step 1: unscrew 3” hose clamp at air
intake box and throttle body.
.
Step 1: Engine Must Be Cool. Remove
engine cover
P/N:17755.03
Step 1 Step 2 Step 3
Step 3: Remove the (2) M10 bolts
securing intake tube to top of
radiator. Place off to the side.
Do not disconnect air sensor.
Step 4: Remove (4) T-20 Torx head
bolts from throttle body. DO
NOT DISCARD. Bolts should
be reused if vehicle is to be
returned to factory configuration
at a later date. .
Step 5: Remove throttle body and set
below intake. Clean intake and
throttle body.
.
Step 7: Place Throttle body onto spacer
making sure gasket is seated
correctly in throttle body flange.
Install the top M6 x 55 (short)
shank bolts and washers. Start
threads but do not tighten.
Step 8: Install lower M6 x 60 (long) shank
bolts and washers. Start threads
and inspect gasket position.
Carefully tighten bolts working in
a cross pattern. Snug bolts but
DO NOT OVER TIGHTEN.
Step 4 Step 5 Step 6
Step 7 Step 8 Step 9
Step 6: Place Spacer and gasket onto
intake manifold with notch facing
toward the front of the vehicle.
Step 9: Reinstall air tube. Installation is
the reversal of steps (1-3). Check
to make sure tube air sensor has
not been disconnected before
starting engine.