Rugged Ridge XHD Low-Mount Snorkel, 3.6L, 12-14 Jeep Wrangler (JK) - Manual (Page 10)

Page 10 of 22 REV.2 01/15/2013
52
- Inspect front of air tube.
Tube should rest just under
the power steering pump
hard line and next to idler
pulley (arrows). The power
steering hard line can be
moved if needed. Carefully
grab the line and pull up
for additional clearance.
DO NOT OVER BEND LINE.
54
- Place 3” clamps onto both
ends of aluminum air tube.
Lower clamp should
have screw face at the
bottom of the tube facing
outward as shown. The
upper clamp should have
screw face at the top
facing outward.
55
- Place 90 degree silicone
elbow onto aluminum air
tube. DO NOT install 3”
clamp. Test fit of
lower air box will be
needed. Elbow will be
removed prior to final
assemble.
53
- (Note: 3.8L & 3.6L) DO NOT
pull or grab the low pressure
power steering return line.
If line is pulled or forced
O-ring seal can be damaged.
(3.6L shown).
17756.06 - (3.8L) Low Mount XHD Modular Snorkel
17756.08 - (3.6L) Low Mount XHD Modular Snorkel
Snorkel Installation Instructions: 2007-2013 Wrangler 2DR & 4DR Unlimited
56
- Place new lower air box
onto elbow making sure
elbow is fully seated to
air box inlet. Air box
should rest within 1/8” of
rubber grommets.
57
- If air box does not fit
within 1/8” of rubber
retainer grommets the
top of the silicone air
tube will need to be
trimmed. Remove air
box and elbow. If air
box fits correctly
proceed to step (59).