Rugged Ridge Front Tube Doors, Textured Black, 07-14 Jeep Wrangler (JK) User Manual

Jk front tube doors

Advertising
background image

Page 1 of 3

Contents:

Tube Door (latches installed)

(2)

Mirror Stanchion

(2)

Adjustable Nylon Strap

(2)

Anti-Rattle Bumper

(2)

Self Tapping Screw

(2)

JK FRONT TUBE DOORS

11509.10 Front Tube Doors

This product is intended to provide added “off-road” convenience and utility to your vehicle.

This product is not intended to provide occupant containment or protection in the event of an accident or roll-

over. Further, “on road” use may involve increased risk of serious injury in the event of side-impact accidents. To

reduce risk from these types of injuries: Always wear seat belt and shoulder harness for all vehicle occupants.

Keep arms and body inside vehicle. Drive safely, read and understand all manufacturers warnings and product

instructions before installation.

3.

Remove the torx nut from the bottom of each factory hinge pin.

Set these nuts aside to be re-installed on the Tube Doors. To remove the

factory doors, carefully lift the door upward until the hinge pins completely

clear the hinges. It will be helpful to have someone else assist with this step.

2.

Locate the driver side door strap that limits the door opening. At the

end of the strap, disconnect the electrical connector by releasing the red

locking tab and pulling down on the connector. Next, remove the strap

from the hook located inside the vehicle. Repeat for passenger door.

NOTICE ! The door can swing open into the vehicle once the strap is released

potentially causing damage to your vehicle.

1.

Locate the (2) torx head bolts that secure the driver side mirror to the

vehicle. With the driver window open, hold on to the mirror with one hand

while loosening the torx bolts with the other hand. Be sure not to let the

mirror drop after removing these bolts. Repeat for passenger side. Set

mirrors aside to be re-installed on the Tube Doors. NOTE: If you have a 2011

and up model Wrangler and your vehicle is equipped with power mirrors,

disconnect wiring at the mirror after removal.

Advertising