Rugged Ridge Upper Soft Door Kit, Front, Black Diamond, 07-14 Jeep Wrangler (JK) - Manual

Page 1 of 6
Front Door Content: 13711.15 (2dr/4dr)
1. Soft Upper Door frame with Cover
2. Adjustment Collar
3. Allen Wrench
4. Velcro Strip (38” )
Rear Door Content: 13712.15 (4dr)
1. Soft Upper Door Frame with Cover
2. Adjustment Collar
3. Allen Wrench
4. Velcro Strip (30”)
JK Upper 1/2 Door Installation Instructions
Quantity:
2
4
1
2
This product is intended to provide added “off-road” convenience and utility to your vehicle.
This product is not intended to provide occupant containment or protection in the event of an accident or roll-
over. Further, “on road” use may involve increased risk of serious injury in the event of side-impact accidents. To
reduce risk from these types of injuries: Always wear seat belt and shoulder harness for all vehicle occupants.
Keep arms and body inside vehicle. Drive safely, read and understand all manufacturers warnings and product
instructions before installation.
NOTICE: The Rugged Ridge soft upper doors when used in conjunction with the Rugged Ridge Half Doors are
designed to provide the best possible protection from the elements; however, due to the nature and intended
use of this product, extreme conditions such as driving rains, high wind gusts, automated car washes, etc. may
cause leaking to occur.
1. Lower 1/2 doors will need to be cleaned using isoproply (rubbing) alcohol. Clean the 2” along the top edge
where Velcro is to be installed. Installation should be performed between (65F-110F).
Upper Soft Door Kit (Front) 2dr - 4dr JK : 13711.15
Upper Soft Door Kit (Rear) 4dr JK: 13712.15
Quantity:
2
4
1
2
Pic. 1 Pic. 2 Pic. 3
2. Apply Velcro to outer edge of front lower 1/2 door. With 2” of backing tape removed position Velcro 1/8”
below top edge of door (Pic. 2). Working forward from rear of door slowly apply Velcro to door maintaining
1/8” spacing from top edge. For front doors cut a “V” shaped notch 3/4 through Velcro at each bend. This will
allow the Velcro to follow the door line without bunching (Pic. 3). Press Velcro firmly in place to ensure good
adhesion.
Front 1/2 Door Installation