Rugged Ridge Tailgate Assist Kit, 07-10 Jeep Wrangler (JK) - Manual

Rev. 1/12 Page 1 of 3 SB
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.
Step 1. Open the rear tailgate completely until it stops. Pull back the carpet
next to the hinge side of the tailgate.
11252.55
Tailgate Assist JK 07- 10
Contents:
1. Tailgate support strut (1)
2. Drill Bit (1)
3. 5/16 Hex driver (1)
4. #10 Hex Screw (6)
5. #10 Lock Washers (6)
6. Body Bracket (1)
7. Tailgate Bracket (1)
Step 2. Align the body bracket and mark the four hole locations with a felt tip
marker. The bracket should be approximately 1” from the tail gate
seal and 1/4” down from the rolled edge of the fender well. The
mounting ball stud goes on top facing upward.
Step 3. Using the supplied drill bit make four pilot holes in the fender well
previously marked.
Note: Wear safety goggle’s when drilling. Be careful to not drill into wires.