Rugged Ridge Hood Vent Insert, Black, 07-14 Wrangler (JK) - Manual

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
07+ JK Hood Vent
1. Remove hood from vehicle and place on safe
working surface such as a table, sawhorse, or a
large piece of cardboard.
2. Remove windshield washer nozzle, windshield
bumpers, and footman loop.
3. Clean hood with a soft, lint-free cloth and iso-
propyl alcohol.
1. Hood Vent (1)
2. Button Head Bolt (16)
3. Nylon Lock Nut (16)
4. Washer (30)
5. Button Head Screw (12)
1. Drill
2. 5/32 Drill Bit
3. 13/64 Drill Bit
4. 1” Sheet Metal Hole Saw
4. Scissors
5. Hobby Knife or Razor Blade
6. Center Punch
7. 3 mm Hex Key
8. 8 mm wrench
9. Metal file, or sandpaper
10. Touch-up paint
11. Painter’s Tape
12. Electric cutting wheel
Page 1/4
17759.10
Components:
Required Tools:
OMIX-ADA ® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Read all instructions thoroughly before installation.
Rev 01/2014
WARNING ! To prevent bodily injury, wear eye protection and use extreme caution during
entire installation of this product.