Rugged Ridge All Terrain Flat Fender Flare Kit, 07-14 Jeep Wrangler - Manual

Page 1 of 3
JK All-Terrain Flat Fender Flare Kit
11620.10
1. Remove the factory wiring harness connectors that are connected to
the side marker lights. Press the small release tab on the on the connector
and pull straight back. Use caution not to damage the connector as it will be
reused on the Side Marker Relocation Brackets.
3. Remove the factory bolts and plastic push retainers located in the
inner fender well. These are the retainers that hold the inner liner to the
body. Once these are removed, pull the inner liner out of each wheel well.
One of the factory bolts removed will be reused to install the side marker
bracket. The other factory bolts can be reinstalled onto the vehicle. NOTE:
These bolts are required to install the JK Wheel Liners (P/N 11620.50).
2. Remove the inner fender liners. To do this you will need to use a
pointed punch to press in the center of the plastic rivets. The rivets hold the
outer flare to the inner liner. You will need to press the center pin inward
approximately 1/2” to 3/4”. Once you have pushed in the center, the outer
piece of the rivet will need to be removed from the flare. Repeat these steps
for all four flares.
Contents:
1. All Terrain Flat Flares (4)
2. M6 Mounting bolt (22)
3. M6 Mounting Nut (22)
4. Push Rivet (20)
5. Side Marker Relocation Bracket (2)
6. Side Marker Retainer (2)
7. Rubber Bumper (2)
8. M8 Flange Bolt (2)
9. M8 Flange Bolt (2)
10. M8 Flat Washer (6)
11. M8 Lock Nut (2)
6/30/10 SB