Rugged Ridge 7-Inch Fender Flare Kit, 76-86 Jeep CJ7 - Manual

Part Number: 11606.01
7” Fender Flare Kit for
Jeep CJ
INSTRUCTION SHEET
Thank you for purchasing this high-
quality fender flare kit. This kit is
designed to provide 7” of coverage for
wider tire and wheel combinations on all
1955-86 CJ 5, 6 and 7 Jeeps. The front
flares are wider versions of the stock CJ
flare, while the rear flares are an updated
design based upon Jeep TJ flares. These
TJ-style flares will also provide more
room for taller tires.
The flare kit includes: 1 each of Left and
Right front flares, Left and Right rear
flares, and the required hardware to
install the flares.
STEP ONE: Read this ENTIRE
instruction sheet before starting the
project. A complete understanding of
the project and the required efforts will
make the process easier.
STEP TWO: Remove the existing
flares from the vehicle if so equipped.
Although removal of the tires and
wheels is not necessary it makes for
easier accessibility.
STEP THREE: The front flares in this
kit will use the same existing mounting
holes as the OE flares. If your Jeep has
these holes simply bolt the new flares in
place using the included hardware. First
time installations will require locating
the flares, then marking and drilling the
proper sized holes for the mounting
hardware.
The new flare bolts in place easily and
quickly utilizing the existing holes from
the OE flare. This is the left front.
Simply repeat the process on the right
side and you’re halfway finished.
STEP FOUR: The rear flares in this kit
not only provide additiona l coverage for
wider tires, they also provide more room
for taller tires. A slight amount of
trimming will be necessary to provide a
proper fit.
It is necessary to remove the two (2)
locating studs from the rear flares. The
studs are only used on TJs, and are not