Rugged Ridge Inner Fender Liner Kit, 07-14 Jeep Wrangler User Manual
Rugged Ridge For the car
Page 1 of 2
JK All-Terrain Wheel Liner Kit
11620.50
Contents:
QTY
1. All Terrain Wheel Liners
(4)
2. Side Marker Retainer
(2)
3. Push Rivet
(28)
4. M6 Flange Bolt
(8)
5. M6 Flange Nut
(8)
1.
Install OE side marker into the mounting location of the front Wheel Liner and secure it using the Side
Marker Retainer. NOTE: If Flat Fares were previously installed, disconnect electrical connector and remove OE
side marker from the Side Marker Relocation Bracket. Side Marker Relocation Bracket should be removed from
the vehicle. Note: For ease of installation of the side marker retainer, it may be necessary to make slight bends
on the four tabs of the Side Marker Retainer with pliers as shown below.
2.
If Flat Flares were previously installed, remove all bolts
securing the front Flat Flare except for the top 2 bolts. Reconnect
electrical connector to the side marker. Use supplied Push Rivets
to loosely secure fender liner to the mounting holes previously
occupied by the Flat Flare mounting bolts.
NOTE: This product is intended to be used with Rugged Ridge All-Terrain Flat Flares (P/N 11620.10). Instructions
for the removal of OE flares and installation of Flat Flares can be found online at www.omix-ada.com.