Rugged Ridge RRC Tubular Steel Flat Fender Kit, 97-06 Jeep Wrangler - Manual

Rugged Ridge H/D TJ Bolt on Tube Fenders
Part Number: 12004.53 (Pair)
OFF-ROAD USE ONLY
Included Parts: (1) 12004.51 – LH tube fender
(1) 12004.52 – RH tube fender
(1) LH side marker relocation bracket
(1) RH side marker relocation bracket
NOTE: These fenders have been designed to be a true bolt in application with no cutting
or drilling required. The fenders have been designed to use the factory inner fender liner
with most application holes pre-drilled. Because these fenders are designed to be installed
on any TJ from 1997-2006 not all inner fender mounting holes can be accounted for
through the full 9 year production run, but all efforts have been made to make this fender
swap as easy as possible.
The fenders have been supplied with relocation side marker mounting brackets. These
brackets have been designed to allow the movement of the side market lamp to the front
of fender. This is an optional item and has been supplied as a safety feature. These
fenders have been designed for heavy-duty applications and are considered for OFF-
ROAD use only. The owner takes full responsibility for all safety and legal issues if used
on road. It is the owner’s responsibility to check with all state and local laws if intended
for street use. It is the owner’s responsibility to supply side marker lamps if desired.
Before installing fenders please read instructions completely. It is important not to
completely disassemble the front clip of your Jeep® for this installation. If both fenders
are removed at the same time alignment of all front end components will be affected and
proper fitment will be compromised
. Install one side at a time for proper
fitment.
(pg.1)