Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual

Rev. 1/13 Page 1 of 19 SB
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.
11635.10
ZJ Off-Road Flare kit
NOTICE: Body modification is required for the installation of these flares. Cutting of the body
panels is required.
Trimming of body moulding or modification of flares will be needed for a proper fit.
CAUTION: Body and eye protection must be worn during installation of the flares.
Note:
1. Verify fitment of flares to the vehicle prior to install. Some sanding or cutting may be
necessary to ensure proper fitment.
2. Modifications to exhaust system may be necessary. A minimum of four inches of clearance
between flares and exhaust system is required.
3. Bare metal will need to be treated and painted before installation of flares.
Note: Some procedures will be different depending on year and body trim. Please be sure to
follow the steps carefully that apply to your model year.
Painting: For painting the flares see painting procedures at the end of the instructions.
Contents: Front Driver Flare (1) Middle of Rear Wheel Arch Pass (1)
Front Passenger Flare (1) Rear of Rear Wheel Arch Driver (1)
Rear Rocker Panel Cover Driver (1) Rear of Rear Wheel Arch Driver (1)
Rear Rocker Panel Cover Pass. (1) Door Jam Panel Driver (1)
Front of Rear Wheel Arch Driver (1) Door Jam Panel Pass. (1)
Front of Rear Wheel Arch Pass (1) Hardware Kit (1)
Middle of Rear Wheel Arch Driver (1)