Rugged Ridge Fender Flare Kit, 10-14 Ram 2500 and 3500 Pickups User Manual
Page 3
Copyright © 2013 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
All Terrain Flares 10-14 Ram 2500/3500
6. Hold flare to vehicle and start factory bolts
into existing holes and Phillips screws into holes
covered in plastic tabs and clips.
Do not tighten.
Press firmly on flare and tighten all screws. Com-
plete front flare installation.
4. Install screw clip in location marked in image. Clip
will go over oval shaped hole. See next step for guide
on how to install clip.
5. Install plastic tab over hole called out in Step 4.
Install Screw Clip over inner lip edge of fender cen-
tered over plastic tab. Use awl or similar pointed too
to put hole in plastic tab through Screw Clip hole.
Install flare using supplied Phillips Screws. Moder-
ate pressure against the flare may be needed for
mounting holes to align.
Page 3/5
81630.43
Flare
Plastic
Tab
Vehicle
Fender
Screw
Clip
Phillips
Screw