Rugged Ridge Fender Flare Kit, 11-14 Ford Super Duty Pickups - Manual

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
All Terrain Flares 11-14 Ford F250/F350 Super Duty
Page 1/5
Components:
1. Front Flares (2)
2. Rear Flares (2)
Tools required:
- Utility knife
- #2 Phillips driver
- Socket wrench
- 7/32” Socket
- 3/8” Socket
- Awl of Similar Pointed Tool - 6 mm Allen Wrench
Hardware List:
1. M8 Socket Head Cap
Screw (38 pcs)
8. Roll of Edge Trim (30
ft.) 2. M8 Locking Hex Nut
(38 pcs)
9. 1/2” x .260” x 3/4”
Plastic Spacer (4 pcs) 3. 1/4” Locking Hex Nut
(4 pcs)
10. 1/4x20 x 1-1/2” But-
ton Head Screw (4 pcs)
4. M8 Flat Washer (42
pcs)
11. 1/4” x 1-1/4” Black
Fender Washer (4 pcs) 5. Edge Trim Tool
12. Screw S-Clamp (8
pcs) 6. Plastic Square Tab (8
pcs)
7. Philips Screw (8 pcs)
81630.05
Rev - 08/2013
Read all instructions thoroughly before installation.