Rugged Ridge Door Pull Straps, 76-95 Jeep CJ & Wrangler User Manual
Rugged Ridge For the car
1976-1996 CJ-Wrangler Nylon Door Replacement handles
Installation Instructions: (p/n: 11825.01)
(1) Unscrew and remove the two retainer covers holding the OE door handle in place. You will need a T25 Torx
head bit or screwdriver.
(2) Discard old parts as new kit is supplied with all new mounting hardware.
(3) Take new retainer cover and place over grommet eyelet as shown in (Fig.1). In some cases an extra amount
of nylon webbing by protrude past the cover. Fold over if possible and stuff remainder into cover.
Fig.1 Fig.2
(4) Place new handle with cover onto door panel and secure using new hardware supplied. The T25 Tork head
bit or screwdriver will be used again (Fig.2).
(5) In some cases the nylon strap may need to be pushed back under the retainer cover prior to tightening. If
needed this can be accomplished by using a flat head screwdriver as seen in (Fig.3). When finished the cover
plate and grab handle should look like (Fig.4)
Fig.3 Fig.4
(6) Repeat steps 1-5 for the other side.