Rugged Ridge Full Door Arm Rests, 76-95 Jeep CJ & Wrangler User Manual
Installation instructions
11830.01 - 769615
Page 1 of 2
4/04
IMPORTANT NOTICE:
Carefully read instructions before attempting to install this product. Rugged Ridge and or Outland Automotive are in no way
responsible for any damage to the vehicle or persona injury that may occur during the installation or use of this product.
INCLUDED COMPONENTS
2 – Arm Rest Padding
2 – Brackets (Left & Right)
4 – Phillips Sheet Metal Screws
4 – Phillips Machine Screws
INSTALLATION INSTRUCTIONS
1) Remove the factory door closure strap by unscrewing the two screws holding it in place (Figure 1).
2) Attach Bracket to door using the same holes that previously held the factory door closure strap. Use the
included Phillips Sheet Metal Screws to attach Bracket to door (Figure 2).
3) Mount Arm Rest Padding onto Bracket. Use the included Phillips Machine Screws to attach Padding
onto Bracket (Figure 3).
4) Adjust Padding fore and aft to your position of maximum comfort.
NOTE: To mount the Arm Rest on some CJ models, you must enlarge the holes in the Bracket to ¼” and
mount the Bracket to the door using ¼”-20 x ¾” button head screws (NOT INCLUDED).
Made in China
Installation Instructions
Arm Rest
1987-95 Wrangler
Part number: 11830.01 - 769615
Figure 1
Figure 2
Figure 3