Rugged Ridge Sound Wedges With Speakers, 97-06 Jeep Wrangler (TJ) - Manual

Jeep® Wrangler Speaker Box
1997 - 2006 TJ Wrangler.
(Does Not Fit TJ Unlimited)
P/N: 13003.01 (Black box w/o speaker)
13003.37 (Spice box w/o speaker)
13004.01 (Black box with speakers)
13004.37 (Spice box with speakers)
NOTE: The maximum total depth of the
speakers that are installed in p/n
13003.01 and 13003.37 should not
exceed 3.5" (89mm)
Please read and understand all steps involved with the installation before starting.
Installation:
Step (1): Remove sound deadening batting inside of speaker
boxes, and locate (2) supplied sheet metal screws.
Step (2): Position the speaker box in the vehicle where desired.
Mark the hole location on roll bar with a pen or pencil.
Step (3): Drill a 1/8" pilot hole in the roll bar at the location marked.
Install the sheet metal screws through the hole located in
the back side of the sound box with supplied sheet metal
screw (1 screw per speaker)
Step (4): (13003.01 and 13003.37 only) sound deadening batting
should be pulled apart and insert into box after speaker wires
have been run through the top speaker wire hole.
Install your speakers per the manufactures directions.
Step (5): (13004.01 and 13004.37 only) after following steps
above connect speakers and install with (4) screws
supplied.
Step (6): Press speaker screen back onto speaker, careful not
to damage mesh.
Step (7): Repeat for other side.