Rugged Ridge Windshield Mount Light Bar, Textured Black, 07-14 Jeep Wrangler (JK) - Manual

Jeep® Windshield mount (5-tab) Light Bar. (2007 - UP ) 2DR and 4DR JK Wrangler
Page 1of 3
11232.21 Rev (2) 2/24/10
HARDWARE NOTE: This kit has been
designed to reuse factory windshield
bracket mounting hardware. Care should
be taken when removing hardware to
avoid damage to plastic washers.
Item List:
(1) 5 Tab Top Light Bar
(1) LH Mounting Bracket
(1) RH Mounting Bracket
(2) M8 Allen Head Bolt
(2) M8 Nylock Nut
(2) M8 Flat Washer
(2) M8 Lock Washer
Important! Please read instructions completely before installing light bar.
Step 1. Before removing factory windshield brackets place masking tape
around bracket as shown. Make sure that all paint surfaces around
the windshield frame brackets have been covered. Two layers are
recommended. Masking tape will protect the paint during the removal
of the factory brackets and the installation of the new light bar.
Failure to apply tape may result in damage to vehicles finish.
Repeat on other side.
Step 2. Remove factory windshield brackets. A T-40 Torx head socket will
be needed. Carefully remove bracket and place the (6) Torx head
bolts off to the side. They will be reused to install the new light bar
mounting brackets. Repeat on other side.
P/N: 11232.21 Windshield Mount Light Bar
Step 3. If lights are to be installed run required wires through the base of the
vehicles windshield. Each lower mounting bracket is supplied with a
pre-drilled wiring hole. Fish needed wires through grommet and out
the top of the lower mounting tube. It is recommended that
disconnects be installed on all wires to allow removal of light bar if
needed.
NOTICE: Depending on the type and gauge of wire it may be helpful
to lower the front windshield. Please refer to your owners manual
for the proper procedure. Reference light manufactures instructions
for wiring information.