Rugged Ridge LED Tail Light Set, 76-06 Jeep CJ, Wrangler User Manual
Rugged Ridge For the car
Installation Instructions
LED Replacement Tail Light 12403.82,12403.83
For 76-86 Jeep CJ, 87-06 Jeep Wrangler
- 1 -
NOTE: Because the new LED lights use a larger stud to secure the light assembly, it will be
necessary on some models, to enlarge the existing mounting holes using a 5/16 drill bit and drill.
Step 1: Disconnect the battery.
Step 4: Using a 5/16” drill bit and drill, open
up all three mounting holes.(Fig.6)
Caution: When drilling, use caution not
to catch any of the wiring
located directly behind the
body panel.
Step 3: Remove the 3 tail light housing
retaining bolts and remove the
housing from the body.(Fig.2,3 & 4)
Be careful when pulling the tail
light wiring through the hole.
Disconnect the tail light from the
main wiring.(Fig.5)
Step 2: Remove the 4 phillips head screws that
Retain the lens to the tail light
housing.(Fig.1)