Rugged Ridge High-Back Front Seat, Reclinable, Blk Denim, 97-06 Jeep Wrangler (TJ) - Manual

Contents:
(1) MultiMount Seat
(1) LH Plastic Adjuster Cover (4) M13 Flat Washer
(1) RH Plastic Adjuster Cover (4) M13 x 50mm Bolt
(2) Adjuster Knob
(4) Step Bracket (4) M13 Hex Nut
Page 1 of 4
Part Number: 13412.XX , 13414.XX , 1315.XX , 13416.XX
Seat Installation Instructions - MultiMount System (97-06 TJ) (84-01 XJ)
(4) M13 Nut Plate
Pg.1
Installation Instructions
Step 1: Remove the (4) bolts holding factory seats and riser to vehicle. Do Not discard bolts. Bolts will be
required to reinstall seat base to vehicle (Fig.1). Disconnect seat belt warning harness if equipped (Fig.2).
Step 2: Remove (4) M13 factory seat mounting nuts. These are the nuts used to secure the seat to seat riser.
Do Not Discard nuts. Nuts may be used later to reinstall new seats to factory seat riser.
(96-01 XJ, 97 - 02 TJ) : (4) bolts located under seat secure seat to riser. (Fig.3)
(03 - 06 TJ/LJ) : (4) bolts secure seat cushion to lower seat frame. (2) Bolts are located on the back
of the seat under seat fabric (Fig.4). (2) bolts are located on the sides of the seat
under seat fabric (Fig.5). Lift lower seat cushion and remove (4) bolts securing
seat to riser (Fig.6).
(84 - 96 XJ) : Disconnect lower seat cushion from rear of seat base. Flip lower seat cushion
forward and remove 4 bolts holding seat and
seat base to riser.
Step 3: Disconnect factory seat adjuster cable from seat riser if equipped.
(97 - 02 TJ) : Pop seat cable plastic clip off seat riser connection (Fig.7).
(03-06) TJ/LJ): Push seat adjuster cable out of riser mounting bracket (Fig8). Disconnect cable
from seat.
.
(4) Spacer
Please read instruction completely prior to installation. Confirmation of your model vehicle and seat
configuration is needed for proper installation. Instructions will give general installation information. Specific
vehicle information will be called out where needed.
Fig.1 Fig.2 Fig.3 Fig.4
Fig.5 Fig.6 Fig.7 Fig.8
(all models)