Rugged Ridge Neoprene Rear Seat Covers, 03-06 Jeep Wrangler (TJ) - Manual

Page 1
Installation instructions ( p/n: 13263.01 – 13263.04 – 13263.09 – 13263.53)
2003-2006 Jeep® Neoprene Rear Seat Cover
Parts included:
Rear seat upper neoprene seat cover section.
Rear seat lower neoprene seat cover section.
Instructions:
Step (1a) Step (2a)
Step (2b) Step (3a)
Step (3b) Step (4a)
Step (1) Set the cover sections out to
identify the upper from the lower
section (a). The upper sections can be
identified by looking at the slit sewn in
for the release lever on the top upper
section of the seat (if applicable).
Step (2) The process will be easier if you
install the upper section first. Begin by
opening the flaps on the bottom of the
upper cover section. Slide the upper
section over the top of the upper section
of the seat. (a, b).
Step (3) Push the lower front side flaps
between the upper and lower sections of
the seat (a). Flip seat forward and
connect the bottom flaps from the front
and rear of cover to each other using the
attached Velcro (b).
Step (4) Flip seat back into locked
position. Slide lower section cover onto
bottom section of rear seat. Push flaps
between the upper and lower sections of
the rear seat. Flip seat forward. Use
Velcro to attach to bottom flaps of lower
seat section’s carpeted surface. Pull side
flaps around bottom section of seat and
use Velcro to attach to side of the seat
(a). Flip seat back into locked position.
Use Velcro along front of lower cover
section to attach to underside of lower
seat section (b).
Step (4b)