Rugged Ridge Neoprene Seat Protector Vests, Gray, 07-14 Jeep Wrangler (JK) User Manual

Rugged Ridge For the car

Advertising
background image

Installation instructions ( p/n: 13235.30, 13235.32)

2007- up Jeep® Wrangler JK - Neoprene Front Seat Protectors.
Protectors designed to be used on JK's
equipment with or without seat ABS

air bag systems.

Parts included: (1) Front driver's side seat protector
(1) Front passenger's side seat protector

Warning: ABS air bag must not be covered by seat
protector. Make sure that deployment area is
clear of any and all obstructions.

Instructions:

Step(1)

Step (2)

Step (1) Slide, and tilt back of seat forward

Step (2) Remove Head rest

Step (3) Slip protector over back of seat

Step (4) Slip lower nylon strap and
clip between the upper and
lower portions of the seat.

Step (5) Slip Velcro straps through
lower straps plastic loops as
shown.

Step (3)

Step (4)

Step (6) position the side straps in
front of seat adjuster as shown.
Driver's side adjust seat up
as high as possible using the
seat height adjuster lever.
Slip straps between raised seat
and seat riser. Clip straps
together and adjust.
DO NOT OVER TIGHTEN.

Step (5)

Step (6)

Passenger's side place the rear
strap underneath the seat slider and

and seat riser. Adjusting the seat
forward or backwards may help
with locating and pulling inner
most tabs near console. The front
straps should be run under the front
of the seat just behind the seat slider
adjustment arm. Adjust straps but
DO NOT OVER TIGHTEN!

Advertising