Rugged Ridge Fold & Tumble Rear Seat, Spice, 97-02 Jeep Wrangler (TJ) User Manual
Rugged Ridge For the car
Installation Instructions: Standard tilt forward rear seat (1997-2002) TJ
13463.XX
(Step 1 – Fig. A) Front Seat Brackets.
Remove seat mounting bolts from the left and right side of the front floor behind the front
seat risers. Do not mount bracket to floor yet. Install the front seat support brackets to the
fold and tumble seat. Note that the bracket cutout should be facing away from the seat,
and the floor mounting tabs are to point towards each other away from the fender .
Install front seat brackets through seat mounting tabs as shown. Install the plastic bushing
then the bracket followed by the C-clip to secure bracket to seat as seen in (Fig.A).
Align mounting bracket over holes in floor and securely tighten with seat mounting bolts.
(Step2 – Fig.B) Rear Seat Lock
Remove seat belt anchor bolt from floor. Position lock underneath seat belt &
eyelets as shown in (Feg.B). Please note that more than one hole is supplied to
align the bracket with the floor mounting hole and seat lock. If desired an additional
hole can be drilled and the bracket secured with two bolts. Grade 5 or higher bolt
and large washer is recommended (supplied by customer). Reinstall seat belt anchor bolt
through seat belt eyelets and seat lock. DO NOT TIGHTEN YET.
Align seat lock with striker so that seat locks when the seat is pushed down into
position. Tighten seat belt anchor bolt. At this time a second hole, if desired,
can be drilled and additional hardware added (supplied by customer).
Made in China