Rugged Ridge XHD Replacement Top, Black Diamond, 07-09 Jeep Wrangler (JK) - Manual

2DR JK SOFT TOP INSTALLATION INSTRUCTIONS 07-09
Step 1. Remove the quarter windows and rear window. Remove the tailgate bar
from the rear window. The tailgate bar will be reused with the new top.
Release the plastic window strips that retain the top above the front doors.
Release the windshield latches on the front header. Do not fold the top back
at this time.
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.
Step 2. Release the rear corners of the top. Pull down and out on the rear corners
to remove the fabric from the belt rail. Repeat this procedures for both sides.
Step 3. Remove both sets of (4) Phillips head screws on the rear bow using a (#2)
Phillips head screwdriver. Do not use power tools. Set the screws aside as
they will be used to attach the new top.
Step 4. Unfasten the hook and loop retainer that secures the top to the bow located
above the roll bar. It may be necessary to lower the top at this time to aid
in the removal.
13736.35
Rev. 4/11 Page 1 of 3 SB
Kit Contents:
1. Soft top fabric skin
2. Rear quarter windows (2)
3. Rear window
Tools required:
1. Phillips head screwdriver
2. Safety goggles
3. Tape
Note: For ease of installation temperature must be above 72 deg Fahrenheit. Safety
goggles should be worn when handling old deteriorated fabric.
13736.36
13736.01