Rugged Ridge Roll Bar Top, Black Denim, 76-86 Jeep CJ7 and 87-91 Wrangler (YJ) - Manual

13554.xx Page 1 of 4
04/16/07
IMPORTANT NOTICE:
This Roll Bar Top installation requires drilling. Carefully read the instructions before attempting to install this
product. Rugged Ridge is in no way responsible for any damage to the vehicle or personal injury that may
occur during the installation or use of this product.
INCLUDED COMPONENTS
1 – Roll Bar Top
2 – “J” Hooks
2 – Curved Bars
1 – Straight Bar
2 – Plastic Feet
2 – Plastic Brackets
4 – Large Sheet Metal Screws
2 – Sheet Metal Screws
2 – Large Bolts
2 – Small Headless Bolts
INSTALLATION INSTRUCTIONS
1) Unfold the Roll Bar Top and lay it in direct sunlight for at least 30 minutes. For best
results the temperature should be over 70 degrees. If it is not you can still install the
Roll Bar Top but you will need to tighten the straps after use until stretches smooth.
2) Position the Plastic Bracket on the center of the roll bar, mark and drill (Figure 1).
Distance from the bottom center hole and bottom of the roll bar should be
approximately 16” inches. NOTE: The larger hole on the Plastic Bracket should face
the outside of the Jeep.
Installation Instructions
Roll Bar Top
76-91 CJ7 & Wrangler
P/N: 13554.XX
If your Jeep did not come with a soft top or windshield channel is missing, you will need to
purchase a windshield channel from your Rugged Ridge distributor P/N 13308.01
Larger Hole Figure 1