Rugged Ridge Island Topper, Black Diamond, 07-09 Jeep Wrangler (JK) User Manual
Page 2
Step (5) :
Attach the rear side strap. Pull Snug
Step (6) :
Attach side Velcro straps over and around roll bar
Do Not Tighten at this time.
and plastic door brackets as shown. Note: Straps
All straps are to be tightened at the
will need to run between plastic side rail on
end of installation. This will allow the top
summer top and plastic door brackets as
be pulled flat and snug to vehicle body
shown. If top is used without plastic door brackets
than Velcro straps are to be looped around side
roll bars and secured.
Step 5
Step 6 (A)
Step 6 (B)
Step 7
Step (7) :
With all straps secured, fold plastic side
Step (8) :
With the left and right side Velcro
rails under plastic door brackets and
straps secured and plastic side
lock into place. Repeat this step for
rails secured proceed to pull the
the rear side rails on 4DR JK's.
center cross bar straps, rear side
straps, and side straps tight.
Step 8 (A)
Step 8 (B)
Step 8 (C)
Step 9
Step (9) :
Your Rugged Ridge Summer Top has
NOTE:
These instructions are a general
two front mesh pockets designed for
guide for installation on both 2DR
small item storage. It is important to
and 4DR JK Wranglers. There may
keep the zipper closed at all times
be some slight variations of the
when items are stored. Heavy objects
steps listed for installation on
SHOULD NOT BE STORED in these
2DR Wranglers. This will include
pockets.
the side straps for the Summer
Brief Tops.
Step (10) :
When summer tops are installed without
side plastic door brackets there may
be slight wrinkles in the tops. This is
caused by the different shape of the
roll bar in relation to the front windshield
and summer top header. This is normal.
Pg.2
Step 10