AEG LAVAMAT 76800 - Manual (Page 27)

27
3
Special spanner A and sealing caps B
(2 units) and C (1 unit) come with
the appliance.
3. Use special spanner A to remove
screw D and the compression spring.
4. Use sealing cap C to cap the hole.
5. Use special spanner A to remove the
two screws E.
6. Use special spanner A to remove the
four screws F.
7. Remove transit bar G.
8. Screw in the four screws F again.
9. Use sealing caps B to cap the two
large holes.
Important: Press all sealing caps B
(2 items) and C (1 item) in firmly so
that they snap into the rear wall.
Where to install
Important! The washing machine must not be operated in a room
where there is a danger of frost. There is a risk of frost damage or ad-
verse effect on the perfomance of the machine. Frost damage is not
covered under the warranty.
• The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpeted floors or soft floor
coverings.
• The surface on which the appliance is to be installed must be clean
and dry and free from grease, so that the appliance does not slide.
• If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.
If the appliance is to stand on a floor which moves, e.g. a suspend-
ed wooden floor:
Place the appliance in an area as close as possible to a corner of the
room.
1. Screw a water-resistant wooden board (at least 15 mm thick) onto at
least 2 of the floor joists.