Rugged Ridge Soft Top, Dark Tan, Tinted Windows, 97-02 Jeep Wrangler (TJ) - Manual (Page 5)

Step (8) : Locate the left and right quarter window
panels and orient them with the zipper
slider about 10" - 12" along the top.
Step (9) : Roll the plastic along the front of the panel
into the channel of the door surround on
the vehicle.
Step (10): Locate the plastic strip sewn to each side
of the top, above each door. Slip the strips
into the channel in the door surround above
the door opening.
Step (11): Close the zipper on the quarter panels the
rest of the way to the lower rear corner of
the panel.
Start at the rear and roll the plastic along
the bottom of the panel into the retainer on
the vehicle. Then fasten the hook and loop
strips along the rear of the panel to the top.
Step (12): Remove the rear window from the box and
lay it flat with the backing side up. Locate
the tailgate bar set aside in step one. The
bar has a "C" shaped channel, when viewed
from the end. Orient the bar with the round
seal down and slide the "C" channel on the
retainer onto the tubed strip sewn to the
backing side of the rear window.
Step (13): Insert the tailgate bar into the mounts on
each side of the tailgate opening with the
vinyl side of the rear window towards the
outside of the vehicle.
Pg.5