Rugged Ridge Sailcloth Bowless XHD Soft Top, Spice, 97-06 Jeep Wrangler - Manual (Page 2)

Jeep® TJ Wrangler XHD Bowless Top (With Door Hardware)
Page 2 of 7
(Step 6) - Pull top forward and lock front plastic retainer into windshield header. Make sure retainer
is held in the full length of header (pic.3).
(pic.1) (pic.2) (pic.3)
Part Number: 13751.01
13751.35
13751.37
(pic.4)
(pic.5) (pic.6)
(Step 4) - Place metal door surrounds onto roll bar and tub as shown. Roll bar mounting tabs are
to be placed to the underside of roll bar (pic.1). NOTE: new surrounds can be installed with
or without rubber seal mounted to body tub at door opening.
(Step 5) - Place (2) M8 caps head bolts and flat washer through roll bar as shown. Do not install M8
plastic knob yet. Repeat for other side (pic.2).
(Step 7) - Place sides of top over metal surrounds. Make sure foam pads rest between metal surround
and roll bar (pic.4).
(Step 8) - Pull front and rear eyelet flap over roll bar and around door surround. Slip eyelets over M8
caps head bolt threads. Install M8 plastic knobs over eyelet flap. (Do Not Tighten) at this
time. Repeat steps (7) and (8) for other side (pic.5).
(Step 9) - Pull center flaps tightly around door surround and secure hook side of Velcro to loop side
sewn to underside of soft top.(pic.6).
(Step10) - Pull rear flaps tightly around door surround and secure hook side of Velcro to loop side
sewn to underside of soft top(pic.7).
(Step11) - With both sides secured to door surround and soft top pull metal door surround away from
roll bar to tighten top (pic.8). While holding surround in place tighten plastic knobs.
(pic.7)
(pic.8)
Rev.1 3/14/2012