Rugged Ridge Tire Plug Repair Kit for Off-road - Manual

Contents:
(1) H/D Radial T-Handle Punch
(1) H/D Radial T-Handle Plunger
(20) Rubberized sealing plugs (4 packs of 5)
(2) Allen Head Wrench
(1) Replacement Punch Head
(1) Replacement Plunger Head
(1) Hard Plastic Case
Page 1
Omix-Ada Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024
15104.51 OFF-ROAD tire repair kit
Installation Instructions: Heavy Duty Tire Repair kit
CAUTION : This kit is to be used for temporary repairs only. Repaired tires should be taken to a
certified tire service center for inspection and replacement if needed. On road Repairs
should be made to the center tread area only. All hole repairs are to be made inbound
1" from edge of tire tread. Sidewall of tire CAN NOT BE PLUGGED for on road use.
(1) Locate puncture.
If object cannot
be located soap
water should be
used. Bubbles will
indicate hole
location.
(2) Remove object
from tire. For on
road repairs hole
must be located
1" inbound from
either edge of
tire tread.
DO NOT REPAIR
if hole is located
near or on the
sidewall of tire.
(3) Insert T-handle
punch into hole.
Work punch in
and out several
times to clear
hole for plug.
(4) Insert rubber
plug into eye of
T-handle plunger.
Place plunger
eye into hole
and insert to
base of plunger
extractor.
(5) Press down on
plunger extractor
and pull up on
T-handle to insert
rubber plug into
tire.
(6) Cut off ends of
rubber plug at
tread. Slowly
inflate tire and
checking for
leaks.