Rugged Ridge Winch Mounting Plate, 87-06 Jeep Wrangler - Manual

YJ-TJ Universal Winch Mounting Plate
(p/n: 11238.10) 1987-2006 Wrangler
Warning: This plate has been designed and built to offer years of trouble free operations but
is only as safe as the individual that uses it. Please read all safety information and installation
instructions pertaining to the winch that is to be installed prior to any operation. This plate has
been designed to be used with most standard winch applications and is rated for use with standard
bottom mount winches (foot prints 10” x 4.5”) up to 9500lbs pull rate. This plate can not be used
with the Warn® M8274 series winches. This plate has been designed to reuse OE bumper
attachment bolts that are at least grade 5 or better. It is recommended that if you are unsure of the
grade of your bolts to please replace with new approved hardware. (Note: some Jeep® mounting
bolts could be metric. In this case the bolts must be an 8.8 or numerically large in grade.
8.8 = grade 5, and 10.9 = grade 8
Please follow all safety procedures during any winching operation and never exceed the load
rating of the winch. Never use the universal plate or winch in an unsafe manner and always keep
individuals clear of winch cables when in use. The doubling and or tripling of the winch cable by
use of snatch blocks can easily produce a load rating that is greater than both the winch and or the
winch plate designed limits. Always use common sense when using your winch.
Parts List:
(1) Universal Winch Plate
(2) Spacer Plates.
Pg. 1