ATEN CS-104 - Manual (Page 4)

+DUGZDUH ,QVWDOODWLRQ
+DUGZDUH 5HTXLUHPHQWV
You will need to have the following:
To connect to a Monitor:
•
A VGA, SVGA, or Multisync monitor card installed in each PC.
•
One VGA, SVGA or Multisync Monitor
To connect a Mouse:
•
DB-9 serial port or 6-pin mini-DIN PS/2 bus mouse port in each PC.
•
One PS/2 mouse and/or a DB-9 Serial Mouse
To connect a Keyboard:
•
5-pin DIN AT keyboard port with +5V DC on pin 5 and ground on pin 4, or a 6-pin mini-DIN PS/2 keyboard
port with +5V DC on pin 4 and ground on pin 3.
•
One PS/2 style Keyboard or one AT style Keyboard.
The CS-104 is cascadable up to a depth of 3 stages which is selected by DIP switch settings.
One Stage:
In a one-stage system, a single CS-104 can control up to four computers. The DIP switch #4 is set to the
ON position. Connect the monitor output, mouse port, and the keyboard port of a computer to one of the
CS-104’s available PC port groups with the appropriate cables. The 5-pin DIN is for an AT style PC key
board and the 6-pin mini-DIN is for a PS/2 style keyboard. You can use either port for each computer.
Fig. 1: A One Stage installation of the CS-104
Keyboard
Video
Mouse