Australian Monitor AMPCS60 - Manual (Page 4)

I N S TA L L AT I O N
4. Wiring
Remove the supplied 4-pole connector from the speaker, and terminate to speaker cable
(see diagram 3).
Loop-through terminals are provided (see diagram 4). When this wiring method is
used, you should be aware that when a speaker is not plugged in there is no path to
subsequent speakers.
An alternative is to wire incoming and outgoing cables in parallel. Pin 2 is +'ve and pin 3 is -'ve.
D i a g r a m 4
1 2 3 4 1 2 3 4 1 2 3 4
+ -
+
-
To Subsequent
Speaker
Speaker 1 Speaker 2 Speaker 3
Power Amplifier
A M P C S 6 0 I N S T A L L A T I O N & O P E R A T I O N M A N U A L P A G E 5
I N S TA L L AT I O N
3. Position mounting hardware
If working from below ceiling, mounting hardware can be disassembled, passed through
the hole, and then reassembled.
Tile Rails should be positioned over the ceiling grid, C-Bracket slides engaged, and then
locating screws tightened. See diagram 2.
D i a g r a m 2
A M P C S 6 0 I N S T A L L A T I O N & O P E R A T I O N M A N U A L P A G E 4
CAUTION: Always use all supplied mounting hardware with ceiling tiles.
D i a g r a m 3