Australian Monitor XRS Manual - Manual (Page 5)

Made in China
Frequency Response (-3dB) 65Hz-18kHz Sensitivity (dB 1W 1m) 92 dB Impedance 8 Ohm Recommended Max Power (Program) 200W
1-
2 Way Full Range Speaker
Built-in Passive 2 Way Crossover
1+ 1- : INPUT
SN:
XRS8B
2+
1+ 2-
Made in China SN:
XRS8ODV
100V 25W/70V N.C
100V 50W/70V 25W
8 OHM BYPASS
100V N.C/70V 100W 100V 100W/70V 50W
2 Way Full Range Speaker
Weather Proof 100V/70V
Frequency Response (-3dB) 65Hz-18kHz Sensitivity (dB 1W 1m) 92 dB Impedance 8 Ohm Recommended Max Power (Program) 200W
PAGE 5 XRS SERIES INSTALLATION AND OPERATION MANUAL
XRS REAR PANEL – PASSIVE AND CONSTANT VOLTAGE
1 Speaker Input
The input connector is a 4 pole twist lock, speakON
compatible connector. Pins 1+ and 1- are wired to +ve and
-ve respectively of the speaker. The XRS10 and XRS12 have
two connectors. They are wired in parallel so either connector
can be used as an input, the other as a loop through.
1 1 2
XRS8B shown here XRS8ODV
1 Voltage Tap Select Switch
A switch on the back of the XRS ODV speakers allows
you to select the desired transformer tap. Each speaker
has 3 taps at 70.7 V and 100 V, as well as a low impedance
transformer bypass option.
2 Fly Lead (Speaker Input)
The XRSODV series speakers come supplied with a 2 core
flying lead as input to the speaker. The flying lead wires
are red (positive +) and black (negative -) and are used as
an input to the speaker for both constant voltage and low
impedance inputs