Australian Monitor DPRM - Manual (Page 6)

PAG E 6
D P R M I N S TA L L AT I O N & O P E R AT I O N M A N UA L
P R O G R A M M I N G
The following steps are for programming the remote control
panel for use in ZONE X:
Hold down the RESET button on the back.
While holding down the RESET button, hold down both the Up and
Down volume buttons.
Release the RESET button.
The remote control panel will beep 3 times indicating it is in
program mode. The BUSY LED will stay lit while in program mode.
Press the Up button X times (the unit will beep each time).
Eg. for ZONE 4, press 4 times
Press the Down button.
The BUSY LED will go out. The remote control panel is now
programmed.
Confirm that the panel is controlling the correct zone.
NOTE: You have approx. 2 secs to begin the programming
and between button presses else it will exit
programming mode.
☛
1
2
3
4
5
6
7
8